How can we help?

Follow

Setup videos for Roost Smart Home Devices

Connecting your Roost Smart Home device is easy, but you do need to pay attention to a few details.

Most people are able to connect Roost devices successfully after a few tries, so don't worry if your device does not connect on the first try! If at first you don't succeed, before you try again, please:

  • Make sure the position of the device with respect to your phone speaker is optimal (not applicable if you have a Roost battery with foam packaging)
  • Remove your phone case (not applicable if you have a Roost battery with foam packaging)
  • Verify your Wi-Fi network password and that you are connecting to a 2.4 GHz band of your Wi-Fi network

Our friendly and knowledgeable support team is here to help! Contact us anytime!

Roost Smart Leak Detector Setup Video

Please make sure the LED on your Roost Smart Water Leak and Freeze Detector is blinking green at the start of the setup process! If the LED is not blinking green, before you begin the setup process you will need to reset your leak detector.

This 4 minute video will show you how easy it is to setup you Roost Smart Water Leak & Freeze Detector. There is not an audio track, but you can hear the single beep after you remove the pull-tab and the success tone at the end of the setup.

If your setup is not successful, please refer to our Help Center article: My Leak Detector Is Beeping And Blinking During Setup

Set up using Roost foam packaging with speaker

Roost Smart Battery Setup video

Please see our Get Started page for complete setup instructions. You may also visit the Get Started section of our Help Center.

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments