How can we help?

Follow

Leak detector setup video

 

Want the details? Or have an older leak detector? Read on

Roost leak detectors can be set up using two methods.

  1. Silent setup mode (Second generation leak detectors)
  2. Audio setup mode (original leak detectors)

The Second Generation Roost leak detectors have the ability to broadcast a Wi-Fi network beginning with "Roost-device".  You temporarily connect to this network to pass your Wi-Fi name and password to the Roost leak detector.

There are two ways to tell if you have a Second Generation device:

  1. Check the packaging or Quick Start Guide on your leak detector. The model RSW-200A is a Second Generation device.
  2. If you open your leak detector to reset it, you can find the MAC address above the battery compartment. If your MAC address begins with "4C", then you have a Second Generation leak detector.

Setting up an original leak detector (audio setup):

Please make sure the LED on your Roost Smart Water Leak and Freeze Detector is blinking green at the start of the setup process! If the LED is not blinking green, before you begin the setup process you will need to reset your leak detector.

If your setup is not successful, please refer to our Help Center article: My Leak Detector Is Beeping And Blinking During Setup

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments